| COOLING CHECKLIST |
HEATING CHECKLIST |
EVAPORATIVE COOLER |
|
Replace air filter |
Replace air filter |
Adjust belt tension (as required) |
|
Inspect evaporator coil |
Inspect thermostat operation |
Check pulley condition |
|
Clean condenser coil |
Inspect burner operation |
Check water float |
|
Inspect blower compartment |
Inspect heat exchanger |
Check water pump |
|
Inspect thermostat operation |
Inspect safety controls |
Check AMP draws |
| Inspect safety controls |
Inspect fan/limit controls |
Check pump starting capabilities |
|
Lubricate all moving parts (if applicable) |
Inspect flue pipe at furnace |
Check water distribution system |
|
Check superheat and sub cooling |
Inspect wiring |
Check condition of pads |
|
Check voltage at condenser |
Inspect belts and pulleys (if applicable) |
Check for adequate coating |
|
Check airflow |
Inspect flame sensor |
Check fan motor |
|
Check starting capabilities |
Inspect blower compartment |
Check wiring |
|
Check AMP draws |
Lubricate all moving parts (if applicable) |
Check fan starting capabilities |
|
Check wiring |
Check AMP Draws |
Tighten wires & wire connections |
|
Check operation pressures in system |
Check voltage at furnace |
Tighten loose screws on panels |
|
Check belts & pulleys (if applicable |
Check airflow |
Start cooler to test equipment |
|
Tighten loose screws on panels |
Tighten loose screws on panels |
Spring startup & turn water on |
|
Tighten wires & wire connections |
Tighten wires & wire connection |
Winterize system & turn water off |